adhesive weight - Typ 397R, 1000×5g, steel, silver

Steel continuous adhesive weight roll from Perfect Equipment with 1.000 segments of 5 g on roll, with protruding liner for easier handling (FL=fingerlift).

Why should you balance tyres at all?

At a speed of 100 km/h the centrifugal force of a 10 g unbalance acts like the force of a sledge hammer. This makes wheels without balancing weights a danger: Without adhesive weights on steel and aluminium rims, wheel suspensions and bearings are subjected to greater stress. Missing balancing weights on steel and aluminium rims can also lead to noticeable vibrations at the steering wheel and in the interior. In addition, non-existent adhesive bars result in increased brake and tyre wear.

Assembly of adhesive weights:

Basically the rim surface must be free of grease, silicone, dust and dry before mounting the adhesive weights. The processing temperature of the adhesive weights must not fall below 10 °C and the surface for attachment to the rim must not exceed a maximum bevel of 15°C; from the hub direction.

Then select the required grammage of the adhesive weights and, if necessary, separate the balancing weights from the adhesive bar or the adhesive weight roll. Then carefully bend the adhesive weight slightly smaller than the rim radius and adjust to the rim radius.

Then you can remove the protective foil of the adhesive weights or balancing weights and stick the weight in the middle of the intended place. Press the weight firmly from the middle to the outer ends - the pressure on the adhesive weights must be at least 10 N/cm². Please make sure that the weight is glued parallel to the rim edge.

Fingerlift

yes